DESCRIPTION
200AX is a glycol ether based stencil cleaner with a concentrated additive that is 100% compatible with all AIM solder pastes and epoxies. 200AX is formulated for application by hand. Where automatic application is desired, the use of AIM’s DJAW Stencil Cleaner is recommended. Unlike other stencil cleaners, the AIM stencil cleaners help to reduce solder paste dry-out while enhancing
its release from even the finest apertures, allowing for a greater number of print cycles between cleaning. For the cleaning of epoxy residues, 200AX will not dissolve the epoxy. In addition, 200AX will not degrade cured epoxy.
FEATURES
- EXTENDS PASTE LIFE
- INCREASES WIPE CYCLE TIMES
- ENHANCES PASTE RELEASE
- ELIMINATES DOUBLE WIPING
- 100% COMPATIBLE WITH AIM PASTE FORMULATIONS
- REDUCES PASTE DRY-OUT
- MAY BE USED TO CLEAN SOLDER PASTE OR EPOXY/ADHESIVE RESIDUES
HANDLING
- 200AX has a sealed shelf life of two (2) years. Do not freeze this product.
- Do not store near fire or flame. Keep away from sunlight as it may degrade product.
- Do not mix used and unused chemical in the same container. Reseal any opened containers.
APPLICATION
- 200AX is shipped ready to use. No mixing or thinning is required.
- Spray 200AX in small amounts on a lint-free cloth or rag and wipe the areas of paste or epoxy residue to be cleaned. It is not recommended that 200AX be applied directly to the stencil. Wipe clean any excess 200AX from the stencil before proceeding.
- PCBs and components can safely be immersed or cleaned with 200AX.
PHYSICAL PROPERTIES
- BOILING POINT 230.6°C
- FLASH POINT 77.7°C
- SPECIFIC GRAVITY .9536
- AUTO IGNITION 227.7°C
- APPEARANCE & ODOUR CLEAR LIQUID / BUTYL ODOUR
SAFETY
- Use with adequate ventilation and proper personal protective equipment.
- Refer to the accompanying Material Safety Data Sheet for any specific emergency information.
- Do not dispose of any hazardous materials in non-approved containers.
